Cautions when using basic dyes

Feb 16, 2020 Leave a message

1. What should I do if I have been poisoned with a basic dye?

Basic dye is a yellow uniform powder, soluble in cold water, easily soluble in hot water and bright yellow, soluble in ethanol and yellow. When the temperature of its aqueous solution exceeds 70 ℃, it will be decomposed into tetramethyl benzophenone. Sulfuric acid is colorless and pale yellow after dilution. After ingestion, there is obvious irritation and pain, and it will cause difficulty in exhalation, which is easy to cause suffocation. First, let the ingested person lift to a place with good air circulation, and take a lot of water to dilute the alkaline bright yellow, immediately call the hospital to wait for help. Quickly taking first aid after poisoning can reduce the adverse consequences of poisoning.

Fire and explosion-proof measures should be taken in the occasion of use. In case of fire, it can be extinguished with water spray, or dry powder or other fire extinguishers can be used. Wear clothing and gloves and protective glasses when using. Do not eat food or smoke while working. After sticking the dye on your hand, you can wash it with bleach or methanol. You can wash your hands by washing it a few more times.

2. How to improve the uptake rate of basic dyes?

Adding salt to the dyeing solution can enhance the dye uptake rate. The ion generated by the salt dissolving in water can reduce the charge effect in the fiber dyeing process, so it has a very obvious effect on the dye. Since cellulose fibers will have a surface potential in a neutral or weak alkaline dyeing bath, they can generate a certain mutual charge repulsion with the dye anion. After adding a salt electrolyte solution, a large amount of positively charged sodium ions combine with the dye anion to maintain It neutralizes the charge, greatly reduces the difficulty in the dyeing process, can promote the close contact of the fiber surface with the dye molecules, reduce the concentration difference between the dye solution and the fiber interface, and enhance the dyeing and dyeing effect of the fiber.

However, the dyeing process of the dye can be gradually divided into three stages: adsorption, diffusion, and fixation. It is not advisable to color too fast in the adsorption stage. If electrolyte is added during the adsorption stage, it may cause dye aggregation and uneven dyeing. , And the electrolyte is added in the middle, not only can avoid the above situation, but also improve the printing and dyeing process printing rate.